Ford Mustang J&M Full Length Subframe Connectors - 30003

This is the first thing that should be done on uni-body vehicles, even if you do not plan to increase the performance of the engine, is the installation of subframe connectors! Connectors assist in maintaining the integrity of the vehicle. Take a close look at any unibody car that has been run hard. The doors don't close quite right and the alignment shop has trouble getting the car to drive straight.

If you want your car to remain rattle free and you want to get the most out of other chassis and engine mods, you have to connect the front and rear frame sections with something stronger than sheet metal. Sub-frame connectors are an absolute requirement for all types of driving.

Features:

Fits 1979 through 2004 Mustangs

A necessity for any performance minded builder

Stops power robbing chassis flex

Improves responsiveness and control

Shaped to hug the floor pan of your vehicle for maximum ground clearance

Doubles as a jacking rail

Capped ends to seal ends from debris and water

Powder coated to prevent corrosion

Weld-in design is far superior and stronger than bolt-in styles